The difference between motor and brushless motors

From now in general use in the industry,there are two main types of motor:efficient rare earth permanent magnet has a motor and the efficient rare earth permanent magnet brushless motor on the market at present most Electric bicycle is still stay in brush motor stage.A brush motor using mechanical commutation,the technical requirements of the control system is low,relative cost is lower than the brushless motor,A brush motor starting torque slightly larger than the brushless motor. But
the fatal weakness is:life is short,large noise and low efficiency.Long-term use of carbon brush wear serious,it is easy to damage.At the same time wear produced huge amounts of carbon dust,These dust fall in gear oil,gear oil accelerate dries up,the motor noise further increased.A brush motor use to within a year or so will need to replace carbon brush,You will find a charge mileage bought less than two-thirds,and climbing when power is insufficient,will burn out the controller.This is because the motor After the replacement of carbon brush and commutator also be ground out a groove,reduce carbon brush contact area,poor contact of carbon brush after electrify which sparks and accelerate oxidation in electricalmotor1.blogspot.com To implement and copper,acmotortrading.blogspot.com lead to the undesirable phenomenon.

Brushless motor electronic commutation replace the mechanical commutation,technically superior to brush motor.Because of brushless motor without gear or gear,the motor,reduce wear and tear The unreliability.Its efficiency within a certain range of current ratio has a brush motor with high efficiency.Brushless motor driving up almost no motor lamination noise,and for up to 10 years to life On.According to the comparison,both brushless motor is better than have a brush.At present,there have been some electric bicycle factory with motor is to switch to the original brushless electric Machine.Brushless motor must be the development direction of electric bicycle. Consumers can come up from appearance to identify motor belongs to "brush" or "no brush" :first,"brushless electric wire" eight root,and the "brush" electric wire to the positive and negative There are two root;Secondly,with the induction motor hand when the drive motor,before and after the brushless motor rotation is easy,and before the "brush" motors turn easily,after when transfer is quite tight.

How to judge the faulty difference of servo motor and servo drive?

Error in the drive,alarm,and then check the manual.If no alarm,that nature is drive failure,of

course,it is pumps also possible that the fundamental servo,there is no fault, But the servo control signal failure didn't move.In addition to the drive error,alarm,and then check the manual,sometimes change is the most direct judgment method,such as X and Z axis Servo in (the same type can be).Or modify the parameters,such as electricalmotor1.blogspot.com the X axis locked,don't let the system to detect the X axis But should pay attention to: the X axis and Z axis swaps,even the same type of imported equipment May also be a problem because of the different load,different parameters.If it is,of course,domestic equipment,usually don't adjusting servo parameters for usage,generally do not have a problem.but Attention should be paid to the X axis and Z axis motor torque power generator rotor and statorare the same,whether the motor screw straight league and electronic gear reduction ratio.